Engineering wizards
EngineeringWizards.
Three guided wizards for sensor selection, tag naming and engineering checklists — built to walk through a decision, not just calculate a number.
Tatva Logix / Engineering Tools
Sensor Selection Wizard
Narrow a sensing principle from the target, the range and the environment, then work through the specification points that decide whether it survives on the line.
Answers narrow the sensing principle. Final selection still depends on target material, mounting access and cycle rate.
Recommended principle
-
Alternatives
Specification checklist
Watch-outs
A starting point for selection, not a specification. Confirm the principle against the actual target material, mounting access and cycle rate before ordering.
Tatva Logix / Engineering Tools
Tag Generator
Generate a consistent tag set from a structured PLC convention or ISA-5.1 instrument letters, numbered and ready to import into the symbol table.
Pattern
-
Generated tags
| # | Tag | Description |
|---|
Reference
Editor: device and signal abbreviations
One entry per line, written as CODE = Description. Changes feed the dropdowns, the generated tags and the CSV. Save keeps the list in this browser for next time; factory reset restores the standard list below.
Adapt the abbreviations to the plant standard before use. A naming convention is only useful when it is applied identically across every project on the site.
Tatva Logix / Engineering Tools
Engineering Checklist Generator
Build a phase-specific checklist for panel build, I/O verification, FAT, installation, commissioning, handover or safety validation, with the scope items that apply to the equipment on the job.
Checklist
-
A structured starting point drawn from common controls practice. Adapt every item to the project specification, the client procedure and the applicable standards before use on site.